A3 LED Light Pocket, Ceiling to Floor Display Kit (Complete System)

Create an illuminated window or reception area display; ideal for estate letting agents, travel agencies, restaurants, hair & beauty salons, small retail shops & large department stores! Manufactured in the UK, these long lasting low voltage ready-to-use LED lighting display kits are of the highest quality; and perfect for commercial advertising, especially at night!

Extra-bright 'pure white' LED lighting is integrated inside high quality slim acrylic display pocket holders. The embossed sheet of LED's refracts light outwards creating an even spread of difussed lighting, that is clean & bright but never glares! The poster display pockets are mounted on a suspended cable system, mounted between the ceiling & floor. These cables support the LED display pockets, which enables their height & level to be easily positioned/repositioned when being set-up; but also provides them the low voltage power they need to illuminate your adverts!

Any posters & adverts can be easily inserted & removed from each light pocket holder, very quickly and by hand (without the need of any additional tool). And these light pockets are dual-sided, meaning when creating a window display, you can place adverts back-to-back in a single holder; gifting you an advertising space for inside & outside your establishment, with just one system!

A ready-to-use A3 LED light pocket ceiling to floor kit consists of:

• A3 LED light pocket holders, portrait or landscape (choose up to 4 pockets per kit)
  Poster insert size (mm): 420 x 297 / (inches): 16.5 x 11.7
• LED lighting driver & power adaptor, including 5m electric-wire & 3 pin plug (UK standard)
  For international usage & additional wire, please contact us
• Ceiling to floor suspended cable system, 2x 4m length (exact cable lengths can be easily cut during installation)
  All fittings in polished chrome finish
• Pocket holder cable supports, 4 per panel

Ceiling to floor cable installation:

1. Seperate the ceiling & floor fittings from the brass screw mounts concealed inside their chrome shell
2. Screw the first brass mount into the top/ceiling, and reattach the ceiling shell with cable
3. With the cable now suspended, align the position for the floor fitting and screw in the second brass mount
4. Thread the cable into 1 electric-wire connector, the floor fitting shell & tension spring, in that order
5. Secure the cable stopper, and cut off any access cable
6. Rettach the floor fitting shell over the brass mount (The spring inside is design to maintain cable tension)
7. Do above steps for second ceiling to floor cable, keeping in mind the width of your LED pockets!
   N.B. A single LED display pocket uses 4 pocket holder cable supports (2 for each cable, left & right!)

LED driver & power adaptor installation:

1. The driver & power adaptor has 3 wires, 2x wires with naked-ends, and 1x 5m wire with 3 pin plug
2. Attach 1 naked-end wire to the electric-wire connector at the bottom of the suspended cable
3. Tighten the small grub screw to secure the wire
4. Attach the second wire to the electric-wire connector on the opposite cable
5. Again tighten the small grub screw on this conector
6. Now simply plug the adaptor into the power socket, and your lighting display is complete!

IMORTANT:

Make sure any power is SWITCHED OFF before installing any fittings!