A4 LED Light Pocket, Wall Mounted Display Kit (Complete System)

Create an illuminated window or reception area wall display; ideal for estate letting agents, travel agencies, restaurants, hair & beauty salons, small retail shops & large department stores! Manufactured in the UK, these long lasting low voltage ready-to-use LED lighting display kits are of the highest quality; and perfect for commercial advertising, especially at night!

Extra-bright 'pure white' LED lighting is integrated inside high quality slim acrylic display pocket holders. The embossed sheet of LED's refracts light outwards creating an even spread of difussed lighting, that is clean & bright but never glares! The poster display pockets are mounted on a wall mounted cable system. The wall systems cable fittings can be installed above and below the window, so cables suspend infront of the opening; or be installed onto an empty wall, to create a standard illuminated wall display feature & advertising space!

The mounted cables that support the LED display pockets, enable their height & level to be easily positioned/repositioned when being set-up; and also feed them the low voltage power they need to illuminate your posters & adverts!

Any posters & adverts can be easily inserted & removed from each light pocket holder, very quickly and by hand (without the need of any additional tool). And these light pockets are dual-sided, meaning when creating a window display, you can place adverts back-to-back in a single holder; gifting you an advertising space for inside & outside your establishment, with just one system!

A ready-to-use A4 LED light pocket wall to wall cable kit consists of:

• A4 LED light pocket holders, portrait or landscape (choose up to 5 pockets per kit)
  Poster insert size (mm): 297 x 210 / (inches): 11.7 x 8.3
• LED lighting driver & power adaptor, including 5m electric-wire & 3 pin plug (UK standard)
  For international usage & additional wire, please contact us
• Wall to wall suspended cable system, 2x 3m length (exact cable lengths can be easily cut during installation)
  All fittings in polished chrome finish
• Pocket holder cable supports, 4 per panel

Wall to wall cable installation:

1. Seperate the wall fittings into 2 pieces, a stem & base
2. Screw each base piece into the wall, one at the top & one at the bottom of your display
3. Rettach the chrome stems, and make sure the holes of the top & bottom stems are align
4. Pass & thread downwards the cable through the top stems hole, and tighten the grub-screw
5. Thread an electric-wire connector onto the now suspended cable
6. Thread cable through the bottom stems hole, and tighten grub screw to secure
7. Cut any access cable away for a neat finish
8. Do above steps for second wall to wall cable fittings, keeping in mind the width of your LED pockets!
   N.B. A single LED display pocket uses 4 pocket holder cable supports (2 for each cable, left & right!)

LED driver & power adaptor installation:

1. The driver & power adaptor has 3 wires, 2x wires with naked-ends, and 1x 5m wire with 3 pin plug
2. Attach 1 naked-end wire to an electric-wire connector of a suspended cable
3. Tighten the small grub screw to secure the wire
4. Attach the second wire to the electric-wire connector on the opposite cable
5. Again tighten the small grub screw on this conector
6. Now simply plug the adaptor into the power socket, and your lighting display is complete!

IMORTANT:

Make sure any power is SWITCHED OFF before installing any fittings!