A0 LED Light Pocket, Wall Mounted Rod Display Kit (Complete System)

Create an illuminated window or reception area wall display; ideal for estate letting agents, travel agencies, restaurants, hair & beauty salons, small retail shops & large department stores! Manufactured in the UK, these long lasting low voltage ready-to-use LED lighting display kits are of the highest quality; and perfect for commercial advertising, especially at night!

Extra-bright 'pure white' LED lighting is integrated inside high quality slim acrylic display pocket holders. The embossed sheet of LED's refracts light outwards creating an even spread of difussed lighting, that is clean & bright but never glares! The poster display pockets are mounted on a wall mounted rod system. The wall systems rod fittings can be installed above and below the window, so rods suspend infront of the opening; or be installed onto an empty wall, to create a standard illuminated wall display feature & advertising space!

The 6mm rods that support the LED display pockets, enable their height & level to be easily positioned/repositioned when being set-up; and also feed them the low voltage power needed to illuminate your posters & adverts!

Any posters & adverts can be easily inserted & removed from each light pocket holder, very quickly and by hand (without the need of any additional tool). And these light pockets are dual-sided, meaning when creating a window display, you can place adverts back-to-back in a single holder; gifting you an advertising space for inside & outside your establishment, with just one system!

A ready-to-use A0 LED light pocket wall to wall rod kit consists of:

• 1 A0 LED light pocket holder, portrait or landscape
  Poster insert size (mm): 1189 x 841 / (inches): 46.8 x 33.1
• LED lighting driver & power adaptor, including 5m electric-wire & 3 pin plug (UK standard)
  For international usage & additional wire, please contact us
• Wall to wall suspended rod system, 4x 1.5m length / 6mm thickness
  (N.B. Each rod has male/female threaded ends, create 3m lengths with 2 rods!)
  All fittings in polished chrome finish
• 4 Pocket holder rod supports

Wall to wall rod installation:

1. Seperate the wall fittings into 2 pieces, a stem & base
2. Screw each base piece into the wall, one at the top & one at the bottom of your display
3. Rettach the chrome stems, and make sure the holes of the top & bottom stems are align
4. Pass downwards the rod through the top stems hole
5. Thread an electric-wire connector onto the now suspended rod
6. Continue passing rod through top stem, until it sits inside the bottom stems hole
7. Cut any access rod length away for neat finish
8. Do above steps for second wall to wall rod fittings, keeping in mind the width of your LED pockets!
   N.B. A single LED display pocket uses 4 pocket holder rod supports (2 for each rod, left & right!)

LED driver & power adaptor installation:

1. The driver & power adaptor has 3 wires, 2x wires with naked-ends, and 1x 5m wire with 3 pin plug
2. Attach 1 naked-end wire to an electric-wire connector of a suspended rod
3. Tighten the small grub screw to secure the wire
4. Attach the second wire to the electric-wire connector on the opposite rod
5. Again tighten the small grub screw on this conector
6. Now simply plug the adaptor into the power socket, and your lighting display is complete!

IMORTANT:

Make sure any power is SWITCHED OFF before installing any fittings!